The FLUID AUDIO AXIS is a large diaphragm condenser microphone with XLR output, designed for recording vocals, podcasts, streaming and instruments. It has a 34 mm capsule with a gold-sputtered diaphragm, a cardioid pattern and a solid brass body. It excels on voice-over, acoustic guitar, piano, percussion, overheads and guitar cabinets.
Capsule and electronics. The 34 mm diaphragm provides the sensitivity and transient detail typical of a studio condenser. The electronics are a discrete Class A FET circuit with 16 dBA equivalent noise. The signal stays clean even on delicate sources such as vocals, backing vocals, piano and strings.
Balanced output. The balanced output is transformer-coupled and designed to work cleanly with studio microphone preamps. The body is solid brass, built for everyday studio use together with the accessories supplied.
High levels and multiple sources. The microphone handles 136 dB SPL at 1 kHz, so you can also use it on percussion, overheads and room recordings. The cardioid pattern and wide headroom make it useful in front of guitar cabinets and other amplified sources.
| Capsule | 34 mm, gold-sputtered large diaphragm |
|---|---|
| Polar pattern | Cardioid |
| Frequency response | 20 Hz – 20 kHz |
| Sensitivity | 12.4 mV/Pa (-38 dBV/Pa ±3 dB at 1 kHz) |
| Output impedance | 100 Ohm |
| Nominal load impedance | 1,000 Ohm |
| Equivalent noise | 16 dBA |
| Maximum sound pressure level | 136 dB SPL at 1 kHz, 1% THD into a 1 kOhm load |
| Signal-to-noise ratio | 77 dB |
| Maximum output | +11 dBu at 1 kHz, 1% THD into a 1 kOhm load |
| Electronics | Discrete Class A FET, transformer-balanced output |
| Connector | 3-pin gold-plated female XLR |
| Body | Solid brass |
The manufacturer reserves the right to change product specifications without notice.
Yes, it requires 48 V ±4 V phantom power. You connect it with the XLR cable to a studio microphone preamp.
Shock mount, 2-layer pop filter, zip pouch, hard case and a 5 m XLR microphone cable, so the microphone is ready for the studio.
Cardioid. Its directivity makes it useful on vocals, instruments and in front of guitar cabinets and other amplified sources.
136 dB SPL at 1 kHz with 1% THD into a 1 kOhm load, so it also suits percussion, overheads and louder sources.